03 SX 2.0 Hesitation
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 8
Likes: 0
03 SX 2.0 Hesitation
Hi guys, I've been searching through the forums but couldn't find what I was looking for.
My SIL has an 03 SX 2.0 base. About a month ago she told me it was running rough, hard to start at times etc. Pulled the codes and the CPS was showing bad. Replaced the camshaft sensor and things seemed ok for a few days. But then she said it was starting to almost stall at stop signs, red lights and as she would try to pull away there was no acceleration / power. Only code it is throwing now is p0441.
The problem is very inconsistent, and I tried to have it duplicate but couldn't.. The wife had it for a drive yesterday and it stalled out at a parking lot while accelerating, and said it would bog out like it wasn't getting fuel when pulling away from a stop sign. I pulled the IAC valve today and it didn't seem to crusty (What i could see anyway) and gave it a cleaning. after a series of start / stops i had it start to bog down on accelerating from a stop 2 times. Did not stall but had some hesitation. Again only codes I see are 0441
any ideas on where I start next? Would the purge solenoid cause this? there are only 109000 KMS on the motor
Any help would be greatly appreciated! Thanks
My SIL has an 03 SX 2.0 base. About a month ago she told me it was running rough, hard to start at times etc. Pulled the codes and the CPS was showing bad. Replaced the camshaft sensor and things seemed ok for a few days. But then she said it was starting to almost stall at stop signs, red lights and as she would try to pull away there was no acceleration / power. Only code it is throwing now is p0441.
The problem is very inconsistent, and I tried to have it duplicate but couldn't.. The wife had it for a drive yesterday and it stalled out at a parking lot while accelerating, and said it would bog out like it wasn't getting fuel when pulling away from a stop sign. I pulled the IAC valve today and it didn't seem to crusty (What i could see anyway) and gave it a cleaning. after a series of start / stops i had it start to bog down on accelerating from a stop 2 times. Did not stall but had some hesitation. Again only codes I see are 0441
any ideas on where I start next? Would the purge solenoid cause this? there are only 109000 KMS on the motor
Any help would be greatly appreciated! Thanks