Hows the truck coming along? I cant wait to hear what all your doing to it and how it responds. [8D]
Keep us informed brotha...it's dark in here hehehe [8D]

 

I think he had a breakdown and took a few weeks off in tahiti or something. His truck is just sitting in pieces and he is just taking it easy. If that isnt what happened, you better have one good excuse for not keeping us up to date.

 

I thought I mentioned it ... maybe not. The #4 cylinder that had the damage wasn't too bad. It needs to be bored .10 over so, I'm doing all the cylinders the same. It could have been sleeved to go back to stock pistons but, I opted for custom cut pistons.

It's in Indiana having a full custom long block built with lots o goodies. It will probably be the middle on Aug. before I get it back. The pistons are made to order and that take almost a month alone.

I'll be doing a motor dyno before it goes back in the truck so, I post some results from that and tracks time when I can.

 

Can't wait to see the numbers

 

Where at in Indiana ?
I'm near the state line maybe I could pop in and borrow it and do all that horrible break in for ya.

 

Lafayette

It's in Lafayette and thanks but, I'll break it in nicely on my 500 mile ride back home

 

Only 45 minutes from me. You want me to go test drive it for a second opinion after Scheid's done with it? You must have deep pockets. I've heard they do decent work (for the most part) but they definitely get their ducats for it.

 

No they aren't cheap but, neither is anywhere else. Most of the cost is in the machine work and parts. I'd say they do more than desent work since they've been doing it for over 25 yrs. and have some of the top pulling trucks in the country. I haven't talked to one person that's said any different but, I suppose there's a few. You'll have that anywhere.

I liked the idea of knowing the place that did the work will still be around down the road.... ya never know about some of the other places.

 

so can we take some guesses as to what's goin on. . .grand poobah??? flux cam??? some stage II injectors???

 

We should all take bets on what it's going to put out on the dyno.Just need a little more info before I place my bet