i am wondering if these come for these trucks?
if so how much?

 

if you could snag a set from a power wagon, and after some fabrication, they may work.

 

I looked into one of these and it is not that big of a deal to setup... you need to mount the release boxwhere the swaybar mounts to the frame on the passenger side, then the wiring. from what I could tell, the links are the same, the only difference is the bar & controller...

 

yah i am gunna see if i can snagone from a power wagon.

 

the only problum i can think of is how it hooks up to the computer in the truck which doesnt let you drive faster then 18 mph with them disconected.

 

I don't know what changed between the years but it might be more difficult to put them on an 01 compared to an 03+ which was similar to the PW.

 

damn didnt think of that.

 

That is what I was thinking... but ya never know though, my brother-n-laws 99 looks pretty close to my 07 under there.

 

i bet with a few modifacations you could get that to fit in. or is that just wish full thinking?

 

Talent and imagination can do just about anything. Take some detailed photos of your underside (with reference measurements) with a digi-camera and look at a 3rd gen 2500/3500 swaybar setup. You may be able to make them fit, but you might be better off modifying some quick-disconnect setups and going manual.
If you get photos of both you could also show them to a fabricator (off-road shops) and they could give you an idea. I couldn't make out your plate but I bet there are some local shops that could do either setup, if you have the pockets for it $$$.