3rd gen axle swap to a 2nd gen?
#1
3rd gen axle swap to a 2nd gen?
hey guys im from the gasser section of this forum, but know one has any info over there on this topic, so I thought id ask yall
So I found a set of 3rd gen 3/4 ton axels with 60k miles on them.
They are out of a 03 hemi truck, and with a little research I found they are 9.25 aam front and 10.5 aam rear, with disk breaks all the way around.
The guy wants $300 for both axels and suspension, and $250 for both drive shafts.
My question is has anyone tried this?
I know the contol arms, coil springs and track bar are interchangable, but will they just bolt in?
What other problems would I run into?
By the way my truck is a 99 1/2 ton ram 4x4.
Ive seen this mentioned on other diesel forums but theres really no in depth info on the swap.
So I found a set of 3rd gen 3/4 ton axels with 60k miles on them.
They are out of a 03 hemi truck, and with a little research I found they are 9.25 aam front and 10.5 aam rear, with disk breaks all the way around.
The guy wants $300 for both axels and suspension, and $250 for both drive shafts.
My question is has anyone tried this?
I know the contol arms, coil springs and track bar are interchangable, but will they just bolt in?
What other problems would I run into?
By the way my truck is a 99 1/2 ton ram 4x4.
Ive seen this mentioned on other diesel forums but theres really no in depth info on the swap.
#2