sounds and smells like a diesel now

 

FYI...

Edge juice w/Attitude won't stack with the Superchips flashpaq programs.

How do I know....um..well, I tried.



I'm gonna run a few more tanks with the flashpaq to determine which one works best. So far, I think I like the edge better. I just wish it could fix on dash spedo.


-Nate

 

FYI...

Edge juice w/Attitude won't stack with the Superchips flashpaq programs.

How do I know....um..well, I tried.



I'm gonna run a few more tanks with the flashpaq to determine which one works best. So far, I think I like the edge better. I just wish it could fix on dash spedo.


-Nate

 

Thanks for the input guys, I think I'm hold off on the quadzilla box for now. I got my answer for the point that I want to install the aero turbine. I'm gonna leave the cat on b/c all the info that I get back is that it's just too loud without it. All in all I can't really complain about the power rite now,,, just a little on the low end, which should be eliminated with the new exhaust. The aero website recommended that this thing be mounted as close to the down pipe as possible, but that would mean losing the cat. I like the sound of loud diesels,,, exceeeeeppt, when I have to take a trip of more than a couple of hours. Rite now I just get this constant drone buzzing from the free flow muffler that I put on, it sounds like a loud freakin rice rocket, I'm looking for a deeper tone. All in all this means one thing MORE MONEY

 

BLKRAM 69, I keep hearing people with the BDTD say something about the low end tourqe and power manager, what is this? I downloaded the Crazy Larry, but don't remember anything like this on it.

 

When I downloaded the new version (2.3.0 I think) onto the truck at one point it asked if I wanted to "enable low end power" or something like that. I said yes and it continued/completed the set up. It was an immediate improvement and was very noticeable. It seems to help with the response and not only on the low end. It seems as though I feel it at any point in mph or rpm's.

As far as the torq. manager........

When I first downloaded the new vers. it was becouse someone on this forum posted about it and said it was crazy good. When I finished the download and tried to select it from the list it required a password and directed me to BD. So I called and the tech that I spoke to basically said that he would give me the code but (strongly) suggested I not use that setting if I needed the truck later in the week. He said that it will almost for sure turn your stock trans int goo..........I said thanks and that was it.

I didnt download the crazy larry vers. but I'm almost 100% that the "low end power" is on that vers. as well but again you do have to select it during the download to the truck-(I missed the first time as I usually go do something else for the 10-20 min it takes to download)

Again, becouse of the QDZ chip and the low end power I keep the BDTD on stock. I bet if you enable the low end and run it on econo/tow or perf. youll feel what I feel and save the cash$$$

 

Just checked I have 2.2.7, I'm gonna try and see if there is a newer version and get it. Thanks for the tip.

 

I just downloaded the newer version (2.3.0) and it has the manager on it. I had already gotten the Crazy Larry and it's not on there. The Crazy Larry is almost not much use either unless you have ALOT of upgrades eg. trans, pryo, and a few others. I tried it twice and things get way too hot, I could just smell things cooking,,, and I didn't even get stupid with it. But thanks for the tip though, this new version is probably what I really needed rather than the Psycho Larry.