Does anybody actually make prefabed pipe kits to replace the cats w/o having to weld? I am getting into the exhaust this weekend on my 06 SRT10 and was just wondering?

 

There are pipes you can use to replace from the manifolds to the cat back. Unfortunatly none of our sponsors carry them, but you can try

www.roeracing.com

I would say try x-metal.com but I was on the site earlier today and it tried infecting my PC with viruses. I am sure Gary will getit fixed, but you may not want to visit it for a couple days, well unless you have a good up to date antivirus program.

 

I'm running the MagnaFlow cat-back system with the X-Metal Eng. mid-pipes without cat's. You can also run the mids with "High-Flow" cat's. Anything is better than stock......

Quick

 

I have 06 reg. cab and i cut the second row of cat's off, no sensor's, then installed x-pipe and bought two maghnaflow bullet's , about 20 inche's long, you can see right thru them but wall's are perforated with glass pack, and don't forget the resonator in back, when i come down road wife hear's me mile away, truck run's awesome

[IMG]local://upfiles/49404/AD1EB32B2AC14ADBA5D977DBC9E9C954.jpg[/IMG]

 

Thanks for the response, I want to be loud and obnoxis if I can. I'll try the cutting off the cats, I already bought a Magna flow exhaust kit. Thanks Again

 

Yea, I tried to go on there after I read your post earlier today and it fragged my work computer, not real good, I hope it works out later.