missfire
#1
missfire
I have a 1996 3.9 dodge ram van, recently had a new control modual fitted as one cyllinder stopped firing, this solved the problem, have fitted new rotor and cap new leads and platinum plugs, now 800 miles down the road 1 cylinder is not firing all the time, comes in and out depending on load, high revs mostly ok low torque problem, noticed one lead was sprarking out at plug end to the shield so replaced that plug and lead. only slight improvment......any ideas guys
Last edited by abouttime; 07-16-2010 at 03:25 PM.
#3
These engine don't seem to work well with the platinum plugs. Also, try the plug wire routing procedure in this TSB.
http://dodgeram.info/tsb/1998/18-48-98/18-48-98-v6.htm
http://dodgeram.info/tsb/1998/18-48-98/18-48-98-v6.htm
#6