Socket size for turning over the motor?
#1
07-17-2005, 01:45 PM
Socket size for turning over the motor?
Could anyone please tell me what the socket size is for the bolt in the center of the harmonic balancer?
I need to turn my motor over a little so I can orient the distributor rotor up on the #1 cylinder at TDC and then install the new ignition wires.
(Yes, we forgot to mark the old ones before removing them!)
This is a 94 Jeep Grand Cherokee with a 5.2 Litre (318) which is common to Dodge Trucks.
Thanks.
I need to turn my motor over a little so I can orient the distributor rotor up on the #1 cylinder at TDC and then install the new ignition wires.
(Yes, we forgot to mark the old ones before removing them!)
This is a 94 Jeep Grand Cherokee with a 5.2 Litre (318) which is common to Dodge Trucks.
Thanks.