Does anyone know if there is a CARB approved roller for use in CA?

 

CARB doesnt care. Put whatever rockers you want on, within reason. Dont put 2.0 ratio arms on or something crazy.

 

Then are you saying I can also put an adjustable fuel pressure reg on as well? it's going to get it anyway, just need to find a good spot for it.

Quote:[ On 2004-05-13 09:52, 4wDakota wrote:
From Crower's Site

Features Include:


17-4 stainless steel body design rated at 180,000 p.s.i.
Works well with stock camshafts and stock springs.
trouble-free, bolt-on installation (approx. 3 hours).
Self-aligning roller tip. Runs with or without guide plates.
Fits under stock V6, V8 and V10 valve covers. No machine work required.
20-25 hp increase on the V8 and 25-30 hp increase on the V10.
Reduced friction for better mileage (up to 20 miles per tank).
50 state smog legal (CARB E.O. #D-410) on all applications.
]

 

Steve, I have been contemplating roller rockers for my ram. Where did you find these that fit under stock valve covers ???

 

.... and do they void your warranty?

 

Yes it voids engine warranty.[]

 

Darn.. I was really liking the potential HP increase and the better mileage.

Thanks.

 

From Crower... that quote in my other post came from a reply on another board. I tried to go find it on the www.crower.com website but had a problem downloading a pdf of their catalog... so you should check their website out. I'm planning on getting the MP covers from SummitRacing.com for $130 (per their catalog) so valve covers wont be an issue for me. I am happy to see the CARB approval [sm=smiley32.gif]

 

^^^Thanks Steve.