01 R/T 3.0 coolant bleeder valve?
#1
01 R/T 3.0 coolant bleeder valve?
It doesn't blow hot air while at idle once i get moving and it cycles threw, it warms up..checked fluids that's good,has pressure. i was thinking a possible air pocket in the system? I couldn't find the bleeder valve though,is there one? Give sight to the blind please.
#2
i think some have a bleeder valve some don't .if you have one it would be at the water outlet where top radiator hose goes into engine should be 3 hoses going into it radiator hose and 2 small hoses and a sensor behind hose, if only 2 hoses and no sensor no bleeder valve. most times when heat doesn't work at idle usually caused by a restriction in heater core or cooling system,weak water pump
#3
#4
Burping it helped thank you
But this new issue among many with this vehicle.
I replaced the distributor core a few months back cause it was shorting out,mis firing,staling & shutting off.
Well with the snow melting, its happened again. I went to buy the book for the elecrical schematics its on order But where is the one place its going to short out at connector,fittings, grounds? Its obviously a electrical shortage because of water im just stumped and will be there all day checking obsolete conections...
But this new issue among many with this vehicle.
I replaced the distributor core a few months back cause it was shorting out,mis firing,staling & shutting off.
Well with the snow melting, its happened again. I went to buy the book for the elecrical schematics its on order But where is the one place its going to short out at connector,fittings, grounds? Its obviously a electrical shortage because of water im just stumped and will be there all day checking obsolete conections...
#5
Here is the factory service manual, maybe it will help. http://tearstone.com/2000-2002-eclipse-service-manual/
Scroll down on the page for individual sections.
Scroll down on the page for individual sections.