SRT-4 /Neon 3D Taillights Install Part I
Thread Starter
|
R.I.P. Dusty (Retired Moderator
Joined: Dec 2003
Posts: 24,471
Likes: 0
From: Alamosa, Colorado (200 yards from the Rio Grande)
SRT-4 /Neon 3D Taillights Install Part I
The instructions that come with the taillights are OK, but not in great detail....(First Picture)
You'll need a panel puller to get the panel plugs out. Don't have one? Try a dinner fork.
Plug one plug on each side and put them in a safe place.(2nd Picture)
Next, pop out the center panel by gripping it by the edges and pulling away from the rear of the trunk. It takes a little effort since it is held in by spring clamps. Fold the carpet material away from the light. (3rd Picture)
[IMG]local://upfiles/894/Ig130587750.jpg[/IMG]
[IMG]local://upfiles/894/Zu666830909.jpg[/IMG]
[IMG]local://upfiles/894/Ns451650637.jpg[/IMG]
You'll need a panel puller to get the panel plugs out. Don't have one? Try a dinner fork.
Plug one plug on each side and put them in a safe place.(2nd Picture)
Next, pop out the center panel by gripping it by the edges and pulling away from the rear of the trunk. It takes a little effort since it is held in by spring clamps. Fold the carpet material away from the light. (3rd Picture)
[IMG]local://upfiles/894/Ig130587750.jpg[/IMG]
[IMG]local://upfiles/894/Zu666830909.jpg[/IMG]
[IMG]local://upfiles/894/Ns451650637.jpg[/IMG]