Can someone give me installation instruction on stage one injectors i just bought them and figured i could get some help on here!!

 

stage 1's? if you have a 04/05 you have those stock.....

but if you need to change or check them, it's pretty easy.

remove the injector cover
unbolt the retainers from the block
disconnect the clips from the injectors (pull the metal tabs off then take the plastic clips off)
pull the rail off (the injectors will come off with it usually, if not then just pull them off)
clean the holes for the injectors and make sure nothing gets in them
remove the old injectors from the rail
put the new ones on the rail
put some vaseline on the o-rings on the new injectors
put the injectors and the rail back on the car
bolt on the rail
put the injector cover back on

that's really about it....

 

ok thank you very much

 

Just a note on initial removal. Use some compressed air and blow around the injector ports before removing the injectors. Dirt and rocks get in there(not sure how) and you don't want any of that to fall in or inhibit a good seal on the injector.

Kris

 

A good idea also, so you don't wear your 93 octane is to remove the fuel pump relay from the engine bay PDC. Start the car and let it run until it dies. Then the rail will be free of excess fuel.