have a friend help... it's always good to have an extra set of eyes look at it.
the hardest part I found was running the wiring harness through the side panel next to the door... good luck ;-)
and finally, if the HOM doesn't work, switch the wires around at the switch... my directions were wrong on mine!!!

good luck!!! I am sure there will be some more advice I forgot!!

 

oh wait... no toys?? never mind what I wrote... hahahaha...

 

No with toys and thnx for the input.....

 

the more friends the better and bring someone that is good at wiring thats what i had my friend doing. i di all the mechanical side i hate wiring.

 

Im scared,i have been looking through the instructions for the toys install and i came across something about hand drilling holes into the computer or something rather important!I would really like some advice from the pros on how to go about that without foo-barrin the whole thing?Any input would be appreciated......

 

It isn't that bad. you just have to make holes in the top of the plastic, so you can pull out the little plastic pin that is in there filling the gap.

some use a sharp bit between the fingers to be safe. I just used a tiny bit and a dremel and was very careful.