DC Strut Tower Bars
Thread Starter
|
Record Breaker
Joined: Jul 2005
Posts: 1,421
Likes: 0
From: Orlando, FL
DC Strut Tower Bars
Okay so I got my DC STB's yesterday. I got the front on with no problem, it fits fine everything is okay. I start the rear and it's just not lining up. I can get one side on but the other side is about .25-.5 inch off! WTF?
So, I jack up the rear of the car, get both wheels off the ground (figured it would take pressure off the struts) and try to put the bar on again. Still can only get one side on!
Is there a trick to getting it on? Or is there something wrong with my car? [&:]
So, I jack up the rear of the car, get both wheels off the ground (figured it would take pressure off the struts) and try to put the bar on again. Still can only get one side on!
Is there a trick to getting it on? Or is there something wrong with my car? [&:]
Veteran
Joined: Aug 2006
Posts: 300
Likes: 0
From:
RE: DC Strut Tower Bars
I don't know what to tell you, the rear DC's bolted right up on my car. Of course I could have trimmed the carpet a little better on one side, not the best job there but the bar dropped right in place.
Captain
Joined: Oct 2005
Posts: 709
Likes: 0
From:
RE: DC Strut Tower Bars
The issue I had with the rear one was that the way it sat made the washer (attached to the nut) hit the welding on the strut bar. I had to go buy a slightly smaller washer and a nut ($.58).Hope this helps...
]