new to dodge forum
Thread Starter
Joined: May 2008
Posts: 2
Likes: 0
From:
new to dodge forum
I am by no means a newbie. I have worked on vehicles since I was 6 years old. None of my vehicles have ever been in a shop except for front end alignment, just because I do not have the equipment. I am cleaning up the property and found a 1980 Dodge Omni in the weeds ( I must be a red neck). The engine was running when parked, the body for the most part is in good shape, the glass other than the windshield has no cracks or pings in them. The pan under the rear seat is rusted badly, I believe the rack and pinion is in good shape as well. If no one wants to buy it is going to the scrap yard in pieces.
Joined: Feb 2008
Posts: 3
Likes: 0
RE: new to dodge forum
Hi,
I'm here trying to get some help. I had a Dodge Sprinter Van for my business,in which Ino longer have. Right before getting rid of the van, I had ordered and received a custom aluminum ramp from Handi-Ramp. Do any of you know someone who might be interested in it? If not, have any of you found the classified section of this site to be effective? The ramp details are:
10' Long
28" Wide
2" Curbs
6" Lip
Weight Capacity of 1000lbs
It cost close to $1,000 and are looking to sell it for $ 450.
I reside in Southern Ca/Corona
Thanks for your help and any suggestions.
I'm here trying to get some help. I had a Dodge Sprinter Van for my business,in which Ino longer have. Right before getting rid of the van, I had ordered and received a custom aluminum ramp from Handi-Ramp. Do any of you know someone who might be interested in it? If not, have any of you found the classified section of this site to be effective? The ramp details are:
10' Long
28" Wide
2" Curbs
6" Lip
Weight Capacity of 1000lbs
It cost close to $1,000 and are looking to sell it for $ 450.
I reside in Southern Ca/Corona
Thanks for your help and any suggestions.
Champion
Joined: Feb 2007
Posts: 2,612
Likes: 0
From: Palm Beach, Florida
