P0340 and P1391 codes
#1
P0340 and P1391 codes
So I have joined cause of all the helpfull people on here,Thanks bye the way !!! I have recently changed ECM because of the P0601 code and front side O2 sensor because of P0155 code.Truck has been great good for about a week and this morning check engine light is on again......throwing the P0340 and P1391 codes,It starts up and stutters like its running out of gas and dies.This is becoming a nightmare.....anyone else with the same issues ?
Jeff
Jeff
#2
Welcome to the site
Is that P0340 or P0430? I just want to make sure
P0340 is Cam Shaft Position Sensor. That could be a bad sensor, loose connection or broken wire to the sensor
P1391 is the same
Google/board searching always helps
https://dodgeforum.com/forum/1st-gen...sometimes.html
https://dodgeforum.com/forum/1st-gen...ode-p1391.html
https://dodgeforum.com/forum/2nd-gen...and-p1391.html
Is that P0340 or P0430? I just want to make sure
P0340 is Cam Shaft Position Sensor. That could be a bad sensor, loose connection or broken wire to the sensor
P1391 is the same
Google/board searching always helps
https://dodgeforum.com/forum/1st-gen...sometimes.html
https://dodgeforum.com/forum/1st-gen...ode-p1391.html
https://dodgeforum.com/forum/2nd-gen...and-p1391.html
#3
#5
#6
#7
resetting the PCM wont hurt but I doubt it will help. Pull your batt cables and wait a few minutes and reconnect them.
ODBii codes are standard. Although the troubleshooting foe the component may differ from one ride to the next. The meaning of the code itself is the same no matter what year/make/model/engine
ODBii codes are standard. Although the troubleshooting foe the component may differ from one ride to the next. The meaning of the code itself is the same no matter what year/make/model/engine