Turn Signals, Hazards, Brake Lights not working
#11
#12
#13
#14
Are there any solutions to this problem I am having the EXACT same issue, I have REAR lights that work but that is it, NO Reverse NO Signals NO Brakes, I tested the 5 pin tow package and its getting Brake lights Rear Lights and Reverse but no hazards or signals. Any ideas?
#15
Still stumped
I tried to follow the wires all the way to the lights, and other than behind the tank I was unable to see any issues. I did notice that my hasard light fuse in the engine compartment fuse box is NOT getting power, good fuse but no power could this explain all of my issues? If so what would you suggest?
So as of now
-NO Turn signals (not even a ticker sound on the dash)
-NO Reverse Lights
-NO Brake Lights
Working
-Headlights
-Tailights
-Trailer Brake Lights
So as of now
-NO Turn signals (not even a ticker sound on the dash)
-NO Reverse Lights
-NO Brake Lights
Working
-Headlights
-Tailights
-Trailer Brake Lights
#16
#17
I am having the same problems on my 97 1500. Third brake light, backup lights, and taillights work but main brake lights, hazards and turn signals don't. All front-end light functions are working. After reading some threads and looking at the diagrams in my Haynes Manuel, I decided to try the multifunction switch, brake switch, and headlight switch from the junk yard with no improvement. I even checked both multifunction switches for continuity and my old one had a problem with #11. I have the factory tow pkg so I thought that might eliminate a hack job but I have not checked the ground. I just sign up here so I am a newbie but I have been trying to read different threads for a while and it seems there could be a few different culprits here.
#18
#19
Stuck there? As in, won't turn, or, you can't tilt it back up?? Should be able to just pull the release lever, and it should come right back up..... should....
Check where the trailer harness hits the rear harness.... (trace if from the plug back to find where they link.) Known problem area on these trucks.
Check where the trailer harness hits the rear harness.... (trace if from the plug back to find where they link.) Known problem area on these trucks.
#20
Yea, it turns fine it is just stuck in the down position. I can move the tilt lever but it does not want to release. The funny thing is the fact I did the same thing to the one in the junkyard. If it hadn't started raining I would have experimented with it a while.
I'll check out the harness when I can this week and post what I find. Thanks!
I'll check out the harness when I can this week and post what I find. Thanks!