Does anyone have a guide on how to install an aftermarket keyless entry unit? No alarms or remote starts, just a keyless entry. Thanks in advance!

 

1998 Dodge Avenger Alarm, Remote Starter, Keyless Entry Wiring Information
Constant 12V+ White Ignition Switch Harness
Starter Black/Red Ignition Switch Harness
Ignition Black/White Ignition Switch Harness
Ignition 2 Blue Ignition Switch Harness
Accessory Blue/Black Ignition Switch Harness
Tach Brown Coil Pack
Neutral Safety Wire Black/Yellow (-) Switch Driver's Side of Transmission
Brake Switch Green Brake Switch
Trunk Pin Red/Green (-) Trunk Light
Parking Lights Green/White 18 Pin Connector at Fuse Panel
Head Lamp Red Light Switch or Steering Column Harness
Factory Disarm Light Green/Orange Driver's Door Boot or Green/White Driver's Kick Panel
Door Trigger Red/Green (-) Driver's Kick or Black 19 Pin Connector on Back of Fuse
Door Lock Brown/White (-) Driver's Kick Panel or Relay below Radio
Door Unlock Brown (-)
Horn Wire Green/Black (-) Steering Column White 3 Pin Connector
Windows Up LF=Green/Red, RF=Brown/Yellow MAIN
Windows Down LF=Green/Black, RF=Green/Yellow


Is the full wiring diagram for wires/location you have to sort thru what you need it depends on the remote unit you have