How-to: Remote key fob programming
#11
#13
I went through the programming instructions and everything went great. The doors locked and unlocked like expected, I programmed 2 remotes and they locked and unlocked again saying the codes were recieved. However when I tested the fob it still did not work. The only thing that works on each fob is the panic button. What is the problem and how can I fix it?
Thanks
Thanks
#14
- Enter your car, and turn the ignition to the "Run" position. Wait for the car's chimes to automatically stop, then press and hold the "Unlock" button on your previously programmed remote.
- 2
Hold the "Unlock" button for 10 seconds, then press and release the "Panic" button as you release the "Unlock" button. - 3
Wait for another chime, then press any button on any other remote you would like to program to sync them to the system. Turn off the ignition when done to end the programming sequence.
#17
#19
I am having the same problem. I have followed the directions word for word and cannot get my locks to cycle. Locks work fine from the switches. I have jumped pin 1 and 4 and I have ground pin 1 to the chassis. Makes no difference. 96 Avenger ES. Car purchase used and did not come with a remote. Any help would be greatly appreciated. Thanx.