how hard is it to replace the transmission mount?

truck is an 02 Durango, 4.7 automatic 2WD

 

bump.

 

need to know asap

 

still waiting.....

 

Since it is 2wd it is very easy. a few bolts and jack the trans up as far as it will go to the floor pans and it should come right out of there. I have never done it on a durango but ost rear wheel drive trans's are set up similar.

 

dude a little patience would help, we dont sit here waiting to answer quesions, we all do this in our free time, we WILL help you if we can, but you need to give it time, giving the thread a bump every 2-3 hours is NOT going to help the thread never even made it off the first page so chill out al ittle and wait, and you WILL get the CORRECT answer from somebody

 

still waiting, i ran into problems with the balljoints, so i didnt get to the tranny mount..... but i did search the fsm, and didnt find what i was looking for

 

ROTFLMAO @ the multi-self bumps between 1AM-6AM. That is certainly a prime time for help and tech assistance, and that's a well known fact throughout the world.

Well... to bad, no answers for you
Antibump.

+1 shrpshtr325

 

sorry, some of us get into jambs and need immediate help...... if it had had soem responses, then it would not have been bumped....

i am online mostly between those hours usually, that's how my schedule has been for several years. others also share this schedule. i spend a lot of time on other truck forums, and other people are also online at those times