I replaced the heater core in my 98 durango 5.9 l motor
I cannot find where the plug from the overdrive button on the gear selector shaft plugs into.can anyone assist
2nd item my cruse control does not work but fuses look ok,everthing according to the book is there and looks like it is proper connected.
can anyone give me hints on where to look next thanks alot .

 

on the 98s im not sure

but here is the entire factory service manual in numerous pdfs

http://www.mediafire.com/?53f6w4a6wme00


if you cant find your answer in there idk where else to tell you to look

 

It should connect to the PCM.


One side of the switch goes to OR/WT.
The other side is BK

It looks like it goes into a Joint Connector bar so look close.