my durango stalled 3 weeks ago, will not start. checked all sensors, wiring and grounds. has fuel pressure spark and good compresion. twice now it has started but runs rough. no codes.
i am very baffled is it the pcm. is there a way to test it???

 

Welcome to the site. I will move this thread to the first generation Durango section,
FF

 

Likely that you have a dead battery. CPS 2nd.

Use the SEARCH feature. VERY common topic... asked weekly.

IndyD

 

Sounds like a Cam sensor or Crank sensor.

 

Has a new battery,cam sensor and crank sensor.

 

Bat can still be bad or poorly connected.

 

Check wiring past the terminals for fraying or possible corrosion, you never know. Also wouldn't hurt to pull 2 of the plugs to check them out and make sure they're not fouled.

 

If it has fuel and spark something should happen. Does it sputter at all when cranking it or is it just a complete dead nothing is happening? If not spray a some ether in the TB and if it spits then it's most likely a fuel problem.

 

All connectors good, all readings good. Shot gas and spray in th. Nothing. Twice in three weeks it did start. But very rough. It did not give codes either. But after it ran, it would not give any hint of wanting to fire at all.

 

Spark plugs also good