Got a good one. My truck won't start. When I leave it in the on position, my oddometer starts to flash, then after a few seconds the words "no bus" appear where the oddometer is. Also, when I get that no bus code, my check engine light, low fuel light, ABS light and my break light all come on. The starter is engaging, but the engine won't turn over. Does anyone have any idea as to what, other than the PCM could be wrong? Thanks in addvance.

 

Maybe a bad battery cell or loose connection.

 

Tried that, the battery is good and I change the terminals out a few months ago. Had some one tell me it might be the speed sensor.

 

my friends d did that too it was water in the connections ,you have three plugs that go to you pcm make sure each of those are dry from any moisture