Do you have to do anything else to put on the 60mm throttle body???
is it worth the price i think i found one for $220

add Hp??

 

you can you dont have to but you should bore out the intake manifold where the tb sits on it i was lucky i have the plastic intake manifold oh and bore it to about 60mm duh any bigger than 55is better and it makes my apexi meaner sounding than before and that was meandont go over 60mm

 

oh and if you have mtx it will make a big diff in every thing hp,throttle reponse,and make it sound nice if you have an auto theres no point in it yet

 

woa i wouldnt say no point in it unlees your talking about the tb .. autos can run damn fine too sir

 

yea im talking about the tb i know autos are fast too didn't you read my post about my stratus kicking that integra's butt lol im not going to swap it to a mtx after that just turbo that strat too the ground ha ha ha ha [sm=happy046.gif]i now have a huge respect for autos

 

ok so the 60mm throttle body is the thing the CAI attaches to right???

and the Throttle Body sits on the thing i have to bore out ??

what if i dont bore it out ??

do i just do it with a drill ??

lol i dont know im engine illiterate

 

yes,
yes,
nothing it will just be more air flow if you do bore it
dremal and sandpaper bits they kinda did it in the sportcompact car at the top of the form' read that'

 

I have the MTX 60mm TB and it's a nice upgrade. You'll most likely loose a bit of bottom and and gain more hp in the top end.

 

what the bottom and top ???

bottom acceleration??

top is speed??

 

so do i just take a ruler and measure 60mm ??or what i wouldnt think that would be very acurate

i would just try to finda 60mm hole cutting bit for a drill but i dont know how big that is so its probly not possible

ill check out the car at the top of the form