will it fit?
Legend
Joined: Apr 2006
Posts: 9,112
Likes: 1
From: Spring, TX
RE: will it fit?
ORIGINAL: spudsterier
it is actually even easier to just unbolt the whole setup from the strut and knuckle....leace the knuckle on the car....i only say this because sumtimes its hard to get the bottom control arm bolt off....
it is actually even easier to just unbolt the whole setup from the strut and knuckle....leace the knuckle on the car....i only say this because sumtimes its hard to get the bottom control arm bolt off....
Thread Starter
|
Record Breaker
Joined: Nov 2006
Posts: 1,791
Likes: 0
From: Detroit Michigan
RE: will it fit?
the bolts are splined you have to do it nut side. which das i found out are 18mm
http://home.hiwaay.net/~lbrewer/howto.html
http://home.hiwaay.net/~lbrewer/howto.html
Legend
Joined: Apr 2006
Posts: 9,112
Likes: 1
From: Spring, TX
RE: will it fit?
ORIGINAL: DOHCgarrett t3
is it hard to do a sway bar without a press?
is it hard to do a sway bar without a press?
ORIGINAL: tdizz07
if i were to go to a junkyard and get the rear disc breaks would i need to get the ebrake cable as well
if i were to go to a junkyard and get the rear disc breaks would i need to get the ebrake cable as well
Thread Starter
|
Record Breaker
Joined: Nov 2006
Posts: 1,791
Likes: 0
From: Detroit Michigan
RE: will it fit?
i plan to go in uniform to the junk yard so they will do whatever i ask them i want them to flip the car onto its top i wont let them have the fun of removing the parts though