where is the oil pressure sensor on a sohc?

 

On the back of the block about midway down.

[IMG]local://upfiles/33897/4656BCD47E7B43FBB99256CCB5B17E54.jpg[/IMG]

 

can you put an apc oil presser gauge on that sencer and witch wire do you tap in to and how do i do an air to fuel gauge every one tells me its the grey wire on the o2 sencer butwhen i did that it show all the bars

 

It's better to replace the sender with an aftermarket one.

 

the kit that i got comes with a aftermacket sencer but if i remove the stock sencer will my oil light come on and can i send you some pictures of what i got

 

the oil light wont come on when the sender is remover becuase it ground out on the block......no ground, no light.....

i made the T fitting i have so that i could put my oil feed line in one outlet, and the autometer oil sending unit in the other...then it just screws into the stock loaction on the block.....
chances are you will have to get a simlar adapter for the aftermarket sender....since the thread pattern should be different then the stock one

 

hey spud check our yahoo .mail ill send you some pictures of what i got

 

Some aftermarket oil senders do fit right in with no problems.

 

i am sure some do...just not the autometer is all i was saying

 

hey das were is the oil presser sencer at