My bottom end budget build PIX ADDED!
#24
#25
RE: My bottom end budget build PIX ADDED!
Balance and assemble for about 350. My dad works at a remanurfacturing shop and has lots of tools, I can get it Re bored by them OR Have it honed (which ever is needed) Wehave to check the bore in cylender1 becausea pistonsidewall let go. So were gunna check foroblongbores and such. Hopefully i can find myself a LOW interest credit card (as thats how im paying for it cuz its better than getting a new car!) And ill hope to get this thing on the road by the end of spring!
#26
RE: My bottom end budget build PIX ADDED!
ORIGINAL: HabitatHxC
I can get it Re bored by them OR Have it honed (which ever is needed)
I can get it Re bored by them OR Have it honed (which ever is needed)
a block needs to be honed after its bored.....otherwise it might not be prefectly smooth
make sure that when they check the bore size, they dont measure it on he very top of the cylinder....you can feel the lip in there and it will throw off the whole bore
when you have the crank balanced, they dont use the block....only the whole rotating assembly components before the block is assembled
#27
RE: My bottom end budget build PIX ADDED!
ORIGINAL: spudsterier
when you have the crank balanced, they dont use the block....only the whole rotating assembly components before the block is assembled
when you have the crank balanced, they dont use the block....only the whole rotating assembly components before the block is assembled
#29