Mechanic's Please Help!?!
#1
Mechanic's Please Help!?!
I need help, one last time before the truck finally goes on the road.
Its a problem with the blinkers.
I replaced the bulbs, noticed it didnt do anything, then replaced both of the tail lights themselves.
That didnt work, then I noticed something wierd...
When I flip the switch inside the truck to turn the blinkers on, The arrows on the dash dont come on.
The front signals dont work either. Fuses are good from what I seen and all the lights inside the truck work except the turn signals, any suggestions?
Its a problem with the blinkers.
I replaced the bulbs, noticed it didnt do anything, then replaced both of the tail lights themselves.
That didnt work, then I noticed something wierd...
When I flip the switch inside the truck to turn the blinkers on, The arrows on the dash dont come on.
The front signals dont work either. Fuses are good from what I seen and all the lights inside the truck work except the turn signals, any suggestions?
#2
The fuse should be #5 (20 amps) and it gets its power from the switch. Do you have power at the fuse?(remember the key must be on) Next in line is the flasher. Do you have power at the flasher? Next is the turn signal switch. I think you will find the problem is before the turn signal switch.
#3
#4
#5
#7
Trending Topics
#9
Make a test light, it is free. If you have an extra bulb just solder two 3-4 foot wires on it. One to the bottom contact and the other to the side of the bulb. Or use one of the extra sockets that you replaced. Ground one wire and touch the other to whatever you want to test for voltage. If the light lights up you have voltage.
#10