i have been lookin to and get one and cant find much. here is my psot about it
https://dodgeforum.com/forum/1st-gen...m-grilles.html

i also found this(1st gen truck half way down page)
http://www.customcargrills.com/products.asp?cat=17

 

all you are thinking of is a grille insert which goes behind the grille which is why they are so cheap. i don't think they would work on the op's truck

 

ok how bout this cazzy if i can get the whole shell would you type of front end fit my core support? any idea on the rust repair panels also thanks for your input

 

what do you mean by whole shell? do you mean a complete unmodified grille? depends on the amount of rust and where it is located. i used bondo over the wheel wells on my 91 and it worked fine but it was done by my dad who is a retired body man and the rust was not too bad.

 

yes the whole shell and i can use bondo i just always have it come back threw like two months later

 

im just showing wat i found maybe it can help him out,id rather have the whole grille covered with a billet aluminum grille

 

As far as the fenders and wheel arches, mine were pretty much gone when I did the body work on my truck in the spring. Now its like 9 months later and no cracks or anything. I think it helped that I used that bondo hair crap underneath, and just a cosmetic layer of regular bondo.

Oh, and maybe you should try to get some more info on these grilles http://www.discountvantruck.com/truc...ruckgrills.htm
Once somebody does find a good one, I might have to spring for one too.