Does anyone know how to bypass the efcm .carb.is not factory and emissions have neen removed but efcm built into air cleaner and wont run unless plugged in..project truck

 

Get a different aircleaner?

Either way, you're in the wrong forum, my man.

 

sounds like you may have the lean burn system. to do thing properly you pretty much need to get a Electronic Ignition Conversion Kits. P3690426
http://www.mopartsracing.com/parts/electronic.html

 

Im sorry,which forum should i be in if you could tell me

 

Im sorry,which forum should i be in if you could tell me

 

you are in the right forum. i think dodge dude might be a bit confused or maybe you originally posted in the wrong section and a mod moved it to the correct section.

 

^Lol
yeah, he posted in the 2nd gen forum originally.

 

What could cause me to be getting power on the negative terminal on the coil..also where does that wire go to. Should it be grounded to the motor??a lot of wiring has been changed on this motor in the past and im not sure where a safe place to run that wire to would be?

 

the ignition box grounds the coil. you will see power on the negative side of the coil until the ignition box grounds the coil. the pickup in the distributor tell the ignition box when to ground the coil.

 

So where should the wire from the neg. side of the coil go to?