1st Gen Ram Tech '93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

1989 fuel injection 318 problem

Thread Tools
 
Search this Thread
 
Old Aug 4, 2013 | 05:36 PM
  #1  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default 1989 fuel injection 318 problem

So have a 1989 dodge ram 250 318 fuel injection. I have replaced fuel filter. Coil plugs wires.distributer cap.check vacuum lines everything checkes out. Problem is truck will start fine little hesitant but some pedal motivation and it goes. Idols perfect . No fluctuation. Drives great but when coming to a stop it dies. Or slowing down at all really . And is very hesitant off the line as well as little back fires here an there not often. Very stumped. As besides this truck runs like new. No problems else were no smoke at start or anything . Any help on this problem. Diagrahms etc will be greatly appreciated. It iS my daily need to fix asap
 
Reply
Old Aug 4, 2013 | 06:13 PM
  #2  
sls001's Avatar
sls001
Captain
Joined: Mar 2006
Posts: 546
Likes: 0
Default

Start by checking for codes and check your fuel pressure
 
Reply
Old Aug 4, 2013 | 07:38 PM
  #3  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default

No codes coming up. And ship said fuel pressure was good so Iuno.
 
Reply
Old Aug 4, 2013 | 07:55 PM
  #4  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

i would guess one of the sensors on the throttle body is causing this issue. could also try adjusting the idle speed control.

 
Reply
Old Aug 5, 2013 | 09:21 PM
  #5  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default

Did the adjustment didn't do anything. Starting to stall worse and worse now and has very hard time starting
 
Reply
Old Aug 5, 2013 | 10:13 PM
  #6  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

have you tested the throttle position sensor?
 
Reply
Old Aug 6, 2013 | 12:31 AM
  #7  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default

No have not any way to test quickly? Don't have a multimeter or anything..
 
Reply
Old Aug 6, 2013 | 01:04 AM
  #8  
crazzywolfie's Avatar
crazzywolfie
Legend
15 Year Member
Liked
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Default

i am pretty sure you will need a multi meter to test test it.
 
Reply
Old Aug 6, 2013 | 10:20 PM
  #9  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default

So that's good. So trucks auto trans . When I put it into reverse or drive the rpms drop from 750 to 350-400 ish then rise back to 750 .and will sometime stall. Or will shortly after while giving gas. Could it be trans related . Have changed/ checked everything and everything is operating great. Really stumped
 
Reply
Old Aug 6, 2013 | 10:56 PM
  #10  
89dodgeshorty's Avatar
89dodgeshorty
Thread Starter
|
Registered User
Joined: Aug 2013
Posts: 13
Likes: 0
Default

Does its problem cold and warm now ... If that helps.
 
Reply



All times are GMT -4. The time now is 01:37 AM.