When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1st Gen Ram Tech'93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I have a 93 360 magnum I bought at salvage trying to start out of truck .It will crank won't start jumping across starter what do I need to do to get fire to coil .I have the ECM hooked up .any help will help
Yea sensor is hooked up I don't know how to get power to ECM I have complete engine harness hooked up to ECM it has three pig tails that hook to another harness I thine one of those should have my hot wire to feed ECm
it has three pig tails that hook to another harness
Pcm gets power from the battery and the ignition switch. Do you have the relays/fuses hooked up? You need the ASD relay to supply power! I would suggest to get a wiring diagram. The new motors are not like the old school ones where all you need was power to the ignition and starter.