Hi there,

I'm new here and was just browsing around and noticed the timeslips section

I have a 1998 Dakota with a 318, posi, half duals and an air cleaner.

I saw a dakota in there that ran like 15.6 with exhaust, chip and a cleaner.

When i ran i ran a 16.1. Now, I'll be soon throwin on a set of Headers, full duals with cutouts, 4.10 gears, a shift kit, power programmer, throttle body and ignition upgrades.

What do you guys think i could run in the quarter with that??

Thanks for your help
Kyle

 

Lower than a 16.1.

 

15.4

 

Anybody have experience with the 4.10's and a Shift kit in the quarter??

 

14.2 with cams and a pcm flash. becarefull with the 4.10. i went with them from 3.55. had to learn how to drive again.backend would just scream all over the place. in the rain i had a hard enough time. but you will like them and there is really not much of an rpm cjange at all and for mileage about 2mile drop over all. just remember to leave a stop sign or traffic light slowly until you get use to them

 

This PCM flash you speak of...Where would I get that done? is that just like a Hypertech Power Programmer or?

 

you can buy a mopar pcm....wayyyy better than stock.

or the one i plan on buying. its a B&G flash.

they replace your stock pcm and make it drive more like a car with all the power of ur truck engine

 

my 99 5.2 5 speed with 3.91 gears, K&N FIPKand a hurst short throwran a 15.7 since then ive added headers full dual exhaust with no cat and a good tuneup with a 180 thermostat and colder plugs im expecting 15.3 - 15.5

 

But Mopar doesn't have a PCM for my year..atleast one that I can find

 

http://www.krcperformance.com/krc/in...&Itemid=26

or

http://www.bgperformancepcm.com/

there ya go buddy