2nd Gen Dakota Tech 1997 - 2004 Dodge Dakota Tech - The ultimate forum for technical help on the 2nd Gen Dakota.

Tilt Wheel and broken wire

Thread Tools
 
Search this Thread
 
  #1  
Old 12-07-2007, 06:29 PM
Radman's Avatar
Radman
Radman is offline
Rookie
Thread Starter
Join Date: Jan 2006
Location:
Posts: 73
Likes: 0
Received 0 Likes on 0 Posts
Default Tilt Wheel and broken wire

My 02 V8 was giving me fits for weeks. I thought the Speed Sensor was my problem so I replaced
it. It didn't help at all. Iasked for help on the Dodge Forum web site. That didn't give me much
help either. Iended up getting it fixed at a local shop. Hereare the results I posted on the Dodge
Forum site.

---------------

Well guys it be fixed... The problem as to why the
ABS, AIR BAG and BRAKE lights would not clear
after start up PLUS, loss of SPEEDOMETER, no duct
control with your heating/cooling system (stuck in
defrost)was a broken wire off the ignition switch.

It took a few hours of trouble shooting plus
air bag and steering wheel had to be removed.

Also had the stock muffler replaced (is was
ready to fall apart) and had a "Cherry Bomb"
part # 88109 (Two output pipes) with new tail
pipes installed. I had them run side by side and
both exit behind right rear wheel. It sounds
nice! Not loud, just nice.

The rear diff pinion seal was also replaced.

All this came to the tune of $659.03 plus tax.

I'm sure the stealership would have been a TON
more.

Now I can put my little 79 AMC back to sleep for
the winter...
 



Quick Reply: Tilt Wheel and broken wire



All times are GMT -4. The time now is 08:21 PM.