map sensor cel codes
#1
01-03-2008, 05:10 PM
Join Date: Dec 2006
Location: Jordan, Ontario
Posts: 283
Likes: 0
Received 0 Likes
on
0 Posts
map sensor cel codes
I threw a CEL Light and these are the codes that came up:
P0108 (M) Map Sensor Voltage To High MAP sensor input above maximum acceptable voltage.
P1297 (M) No Change In MAP From Start To Run No difference is reconized between the MAP reading at engine idle and the stored barometric pressure reading.
Does this mean that the map sensor went for a crap, or could there possibly be something else that istriggering it.I also checked the vacuum lines that run to the map sensor and they seem fine. any help would be appreciated.
P0108 (M) Map Sensor Voltage To High MAP sensor input above maximum acceptable voltage.
P1297 (M) No Change In MAP From Start To Run No difference is reconized between the MAP reading at engine idle and the stored barometric pressure reading.
Does this mean that the map sensor went for a crap, or could there possibly be something else that istriggering it.I also checked the vacuum lines that run to the map sensor and they seem fine. any help would be appreciated.
