exaust/intake gasket done...with stipulations...
#1
exaust/intake gasket done...with stipulations...
ok, so i changed my exaust/intake gasket today, and heat wrapped my exaust mani.
but, i found that the rearmost bolt is sheared inside the block, so its all gonna have to come back out again so i can drill/tap the hole...
couple pix
had to remove power sterring pump
before wrap,
uh, for some reason the after wrap pic did not save on the camera? i gotta figure that out
new gasket
bolt in hole...
and you think the 4 bangers are easy...
some pics are missing from the camera, i'll see about getting ones that will do the job tomorrow when the sun is up..
but, i found that the rearmost bolt is sheared inside the block, so its all gonna have to come back out again so i can drill/tap the hole...
couple pix
had to remove power sterring pump
before wrap,
uh, for some reason the after wrap pic did not save on the camera? i gotta figure that out
new gasket
bolt in hole...
and you think the 4 bangers are easy...
some pics are missing from the camera, i'll see about getting ones that will do the job tomorrow when the sun is up..
#3
#5
#7
**** enough friends together i have all the tools in my truck i could just go pull one from a parking lot....lol nah,
if i did any swap it would be either a 408 or a 4.0...
not sure which would be cooler,
if i did any swap it would be either a 408 or a 4.0...
not sure which would be cooler,
Trending Topics
#9
#10