I put a c-clamp on the pulley that wedged itself on he water pump and held it in place

 

and decided to remove my clutch fan, broke loose extremely easily prolly because of this BFW lol
1.5" wrench


used a c-clamp to hold the pulley in place


the fan looks weird, thought it would be symetric all tthe way around, it looks like a little person lol

 

c clamp would have been better then the vice grips. i had to dremel off a snageltooth.
i didn't have a bfw so i just used wide pliars and a square tube for a cheat bar.
stil glad i did it sounds mellow... until i stand on it.

 

it took me a while to get mine off but it was a toughy, vice grips and a c clamp did me well.

 

i'm trying mine now......damn c clamp is wothless

 

thunder, same here so i used the vice grips on the pulley.
if u do this watch the engine side my grips dug in really bad.

 

i got her off, i just stuck a piece of rubber on the vice grip and yanked the wrench. i dont know about you guys but i felt some better throttle response.

 

That was easy, thanx

 

pssh c clamp useless?! INCONCIEVEABLE(I dont think that word means what you think it means[what a dumb movie])

was it wedged in the waterpump?

 

yo i just rented the tool from auto zone, it doesnt work i know, but i drilled 2 holes and ran bolts through them to go in the holes on the water pump pulley. IT IS THE BIGGEST PITA to drill though those rent-a-tools, i went through over a dozen drill bits and i have a drill DR. to resharpen, just kept burning them up, took 2 hours