i just got my headers in the mail today anything i should know before i embark on the adventure of installing?

 

try not to break anystuds off in the head

 

off topic but how did you make your picture/signature thing?

 

USER made it for me. I think it looks sweet

just pm him and ask for one.


and dont forget to vote for me for ride of the month lets show those rams up

 

/\ /\ Definetly do that dont worry jonny you got my vote i think we need to knock those rams down a peg or two and if anyone wants me to i can make sig pics too (i have PHOTOSHOP) i just dont know how to make them show up

 

You should snap some pictures and do a write-up on your installation; it could benefit people in the future.

 

Recommend using 12 point bolts or hex head bolts for the limited clearances and ease of tightening and retorquing later. ARP makes the 12 point bolts with the right length (longer) for the thick header flanges. Are you installing an aftermarket Y-pipe? Good Luck!!

 

no just the headers it said it is supposed to use the stock flange so should i be ok on that?

 

You should be fine if it is set up for the stock system. Take some pictures. How much did you pay, what type, where did you get them from?

 

they were about 200 bucks they are flowtech shorty headers and i got them from summit racing. i'll have to keep them clean though so they dont rust too bad because i didnt get ceramic coating. I'll post a tutorial like you would when i'm done virused