2nd Gen Neon 2000 - 2005 2nd Gen Neon

Turbo

Thread Tools
 
Search this Thread
 
Old Nov 10, 2007 | 10:59 PM
  #1  
tonxcab's Avatar
tonxcab
Thread Starter
|
New Member
Joined: Nov 2007
Posts: 17
Likes: 0
From:
Default Turbo

Can I put a 2000-02 Hahn Race Craft
Stage2tutbo kit a stock motor in aauto transneon when I'm done rebuilding the motor will it handle it.
 
Reply
Old Nov 10, 2007 | 11:39 PM
  #2  
Adionik's Avatar
Adionik
Champion
Joined: Feb 2007
Posts: 2,546
Likes: 0
From: S.A
Default RE: Turbo

Yes...you can. Then later down the line, you might wanna pick up a tranny rebuild kit.
 
Reply
Old Nov 10, 2007 | 11:46 PM
  #3  
tonxcab's Avatar
tonxcab
Thread Starter
|
New Member
Joined: Nov 2007
Posts: 17
Likes: 0
From:
Default RE: Turbo

Cool that is what I wanted to hear I didn't know if the stock motor would handle it but I think it will be a blast to drive
 
Reply
Old Nov 11, 2007 | 12:00 AM
  #4  
GrApHite03's Avatar
GrApHite03
Joined: Oct 2005
Posts: 2,019
Likes: 0
From: Honolulu
Default RE: Turbo

The motor will handle it, but the auto tranny may not for long. And yes, it is quite a blast... i made 219 wheel hp and 244 wheel tq with a custom kit.
 
Reply
Old Nov 11, 2007 | 12:16 AM
  #5  
AirWolf's Avatar
AirWolf
Joined: Oct 2004
Posts: 4,495
Likes: 0
From:
Default RE: Turbo

You need to have your tranny built up like my 1st gen it has a hahn stage 2 kit also . Then you should be ok.
 
Reply
Old Nov 11, 2007 | 12:26 AM
  #6  
tonxcab's Avatar
tonxcab
Thread Starter
|
New Member
Joined: Nov 2007
Posts: 17
Likes: 0
From:
Default RE: Turbo

Who has a good tranny kit and some prices
 
Reply
Old Nov 11, 2007 | 12:47 AM
  #7  
tonxcab's Avatar
tonxcab
Thread Starter
|
New Member
Joined: Nov 2007
Posts: 17
Likes: 0
From:
Default RE: Turbo

Are these good

High Performance Overhaul Kit for the Neon A670 Automatic Transaxle. Designed for high performance street and strip use, this kit starts with a top quality seal and gasket set. From there a Red Eagle brand intermediate band takes care of tire chirping 1-2 shifts. The forward and high gear friction plates are also a race proven Red Eagle lining with a special double saturation process that virtually eliminates burning warping. To combat a weak high gear clutch pack extra plates are added to the kit to increase clutch capacity for full power shifts. Kolene steel clutches are included that have a superior surface treatment that reduces wear and fatigue from 200% - 500%. New bushings, washers and a filter finish this kit. $249.99



Street/Strip valve bodies that fits Chryslers Neon with A670 Transmissions. The Street/Strip is fully automatic and produces tire chirping shifts. Filter, gasket and instructions are included and installs in less than two hours with simple hand tools. Get the performance you need! Unit only works with the three speed transmissions from 95-2001 $239.99

 
Reply
Old Nov 11, 2007 | 01:01 AM
  #8  
Adionik's Avatar
Adionik
Champion
Joined: Feb 2007
Posts: 2,546
Likes: 0
From: S.A
Default RE: Turbo

If you're sure you have a 3-speed atx, i'd get the valve body. Otherwise, another guy on 2gn turbo'd his atx and used that rebuild kit....no complaints from him.
 
Reply
Old Nov 11, 2007 | 02:23 AM
  #9  
leadspud's Avatar
leadspud
Professional
Joined: Jan 2006
Posts: 202
Likes: 0
From:
Default RE: Turbo

I've been running a turbo on my automatic 2000 neon for about six plus months. No problems yet
 
Reply
Old Nov 11, 2007 | 02:59 AM
  #10  
GrApHite03's Avatar
GrApHite03
Joined: Oct 2005
Posts: 2,019
Likes: 0
From: Honolulu
Default RE: Turbo

ORIGINAL: leadspud

I've been running a turbo on my automatic 2000 neon for about six plus months. No problems yet
what's your set-up/power/boost levels... If you over 200whp you must drive like my grandma. I've seen tons of un-modded ATXs crap out once you cross or get close to the 200 range.

k3v
 
Reply



All times are GMT -4. The time now is 12:18 AM.