spark plugs.
Captain
Joined: Oct 2008
Posts: 719
Likes: 0
From: Northern KY(tri-state)
well bud if you ever want any opinions on anything just throw it on here cause im on in the morning and well give you good ideas
Thread Starter
|
Veteran
Joined: Dec 2008
Posts: 254
Likes: 0
From: prince george, va
the only thing that i know for the time being is that im going for the msd coil pack and the granatelli plug wires from modern performance. i figure later on down the road ill get the new exaust system as well. i am still interested in the intake manifold and throttle body, so if yall have some good choices let me know.
Captain
Joined: Oct 2008
Posts: 719
Likes: 0
From: Northern KY(tri-state)
anything from modern performance is good and msd wires and coil pack is really good also.
i have a strait pipe with no little holes in it and a 2.5" cut out and my car sounds like an srt with no turbo LOL.but like exhaust wise i would consider Borla
i have a strait pipe with no little holes in it and a 2.5" cut out and my car sounds like an srt with no turbo LOL.but like exhaust wise i would consider Borla
Last edited by N3ON; Dec 30, 2008 at 01:01 PM.
Thread Starter
|
Veteran
Joined: Dec 2008
Posts: 254
Likes: 0
From: prince george, va
gotcha. yea im going to order the msd coil pack and those wires later today, i just need to find out if my stock coil pack has round or flat terminals. the header and exaust im looking at is by pacesetter and im wondering if its a direct fit. it says it is but alot of the times you have to make adjustments to get the pipes to fit. which is no biggie. i guess i could contact them just to be sure.
Captain
Joined: Oct 2008
Posts: 719
Likes: 0
From: Northern KY(tri-state)
gotcha. yea im going to order the msd coil pack and those wires later today, i just need to find out if my stock coil pack has round or flat terminals. the header and exaust im looking at is by pacesetter and im wondering if its a direct fit. it says it is but alot of the times you have to make adjustments to get the pipes to fit. which is no biggie. i guess i could contact them just to be sure.
Thread Starter
|
Veteran
Joined: Dec 2008
Posts: 254
Likes: 0
From: prince george, va
modern performance said the header i want is a direct fit and will bolt up to everything that the original did, even the o2 sensor housing is the same. on the exaust, i may have to trim an inch or 2 off the tail pipe and make some notches in the bumper since this is going to be a dual exaust. which is not a biggie for me. as for the coil pack, the terminals for the connector are flat. any advice on the intake manifold and throttle body. i see both on mp's site that look nice.
