Ordered the next piece of my new exhaust system... Pacesetter Y-pipe to go with the LT's I got a few weeks back.

Also picked up a Dorman PCV elbow (for some GM vehicle) to replace the piece of hose that I used to rectify the A/C condensate dripping on the passenger floor pan.

Dorman #47035

It's a nice fit over the condensate tube, and only cost $2.99

 

Filled it up. Getting 13.3 which is a huge improvement after fixing the plenum.

I also removed the front bumper balance and front plate holder. Looks a lot better.

 

ahh eureka springs. one of the few places near here that pot is socially acceptable, with only small fines. smoking in public is a lower offense than jaywalking.

 

Someone had definitely fired up a fattie early yesterday morning, just upwind of my swap space. The occasional odor would waft by as the wind changed direction.

 

The US will have it legalized soon enough, with colorado and washington giving the feds "the business", everyone will see soon enough it doesn't cause any problems and is a taxable crop and all will be forgiven.

 

EDIT: Figured the other picture wasn't a good idea.

 

Didn't see the original, but that's funny as hell.

 

finally fixed my tail light wiring issues... tured out to be the trailer harness like every one said it was. oh well. the ground was majorly corroded on a 4" piece of wire. replaced said wire, installed new but connectors with heat shrink, and all is good!

 

i oiled my exhaust manifold bolts since i will have to take apart my exhaust soon.

 

Drove it to my new job this morning and unloaded the toolboxes. Then realized I had lost the keys to my big box. Ordered a new set with overnight shipping and now im off until wed.