What Did You Do To Your 2ND GEN RAM Today?
Well you have to measure it at the trans side of the drive shaft also correct? Because your pinion angle is the relationship between the trans out put shaft and the pinion gear on the axle.
Captain
Joined: May 2013
Posts: 592
Likes: 0
From: Virginia, Florida
Might be having an issue like that.. Where'd ya get em at?
Administrator
Joined: Apr 2010
Posts: 87,479
Likes: 4,223
From: Clayton MI
LMC truck has them, as well as a few other places.
Do you hear wind noise thru your doors at highway speeds? If so, try bending the window frames in just a bit before you spring for new seals.
Do you hear wind noise thru your doors at highway speeds? If so, try bending the window frames in just a bit before you spring for new seals.
Record Breaker
Joined: Nov 2011
Posts: 1,898
Likes: 162
From: Cle Elum, WA
HB, Yes your pinion angle is set by the transmission angle. You want the two of them to match. When and if you ever go to a CV joint driveline then you set the pinion angle to match the driveline angle -1 degree.
Captain
Joined: May 2013
Posts: 592
Likes: 0
From: Virginia, Florida
not sure, normally have the music up.. will check on the way to work! but the water coming in is becoming a bit of an issue