Changed out rear diff gasket and fluid with Valvoline Syntech 75w-140, now both tires will lock up again.
Got my track tires put on rims and took them out for a ride to lay some rubber down

 

sawed on the tail pipe for an hour, finally bought a sawsaw and chopped the muffler off of her, couldnt hold a lighter to my cig after using the hacksaw LOL sounds a lot better than she did, think im jus gonna put a turn down on'er.....

 

pulled the intake manitfold

 

in addition to my minor head gasket leak....i found in the front of the motor i have a very small coolant leak now which is weird cuz i have just replaced a bunch or parts with NEW parts, not used or remaned. I have a new water pump, timing cover gasket, fan clutch, radiator, all hoses, thermostat, and thermostat housing, and she is still leaking....WTF, could be another bad area of the head gasket............................................ ...

 

i thought it was one of the freeze plugs on the front of the motor that was leaking.

 

ya, wait till you cut the cat off and put a trush welded muffler. sounds so good.

i have a few vids, but ill have to post them later.

 

Yesterday I played around in the snow with her=P

 

Installed My pod and gauges,the paint for the pod didn't match but still looks ok, washed & waxed,detailed interior and engine compartment.

http://i836.photobucket.com/albums/z...m/000_0421.jpg

 

what else did you have to buy to get those gauges to work with what you have?

 

Installed new NKG spark plugs in her=) Surprised she still ran by the looks of the old ones. Plug wires, cap and rotor will be done this summer.