Almost 60 here today so I cleaned my filter for my K&N cai,installed my billet lower bumper inserts,changed the setting on my hypertech from 87 to 93 octane,looked at my spark plugs,looked down my throttle body and saw some black crap.Looked at all the acorns laying on the engine that I have to clean off for the roller rocker and valve covers that I need to install..

 

Took a better pic of my tails after i had redone them, along w/ the fresh bird s***, cleaned it a few days ago and this is what happens:

 

Put my lift in yesturday and I took my stupid mud flaps and bug shield off today

 

Well I took advantage of the nice weather today and started my plenum. Almost done I have to get some new wires cause mine broke. Long process but will be worth it. As soo as I took the plate off I found a lake of oil. And part of the gasket was gone. So I would say that I needed it. I can't wait to start her up. I know I'm going to forget by the time I get up in the morning, does anybody have the wiring pattern for the distributor?? I know somebody has asked for the diagram before but I'm too freakin tired to look at 1:30 in the morning. SO a link to the thread or an image of what goes where would be great.

 

Went for a ride w/three of my buds.

 

Did my back passenger wheel cylinder today. It's nice to have breaks again.

 

Noticed that the driverside axle seal is leaking. Suprised the trans shop didn't notice that when they did the axle joints.... DAMNIT!!!

 

rewired the foglights, cleaned and flushed the radiator

 

Thought I would start out with replacing my leaky timming cover gasket, then move on to
pulling the 180 degree thermostat and go back to stock. From there I will rebuild my alternator and finally, install the new track bar. I STLL LOVE MY DODGE!!!! 256,000 and still kicking A$$.

 

Ordered a new grille assembly from LMC for my sport. Tried to take off my grille and broke pieces! So I bought a whole new grille and grille assembly with all the bits and pieces. After I get it in, I am having the emblem spot filled in and then getting the whole grille painted to color match like my stock sport grille! So I will have a debadged aftermarket/stock sport grille! (: Excited! Pics when I get it put on in two weeks.