What Did You Do To Your 2ND GEN RAM Today?
I just finished installing my 3 inch rough country suspension lift on my 01 1500. I already had 285/75/16 nitto terra graps on pro comp rims. I also had to replace both tie rod ends, both lower ball joints, and one front hub assembly.
Still not sure I like your blue headlights. It's what you like so not bashing ya or anything. I just think clear looked better
0400x that was me at one point. I think there was some others as well. I have found I pretty much only have 1 option for mine and that's under the bed. Hope to install them soon. I was able to test them with a air compressor lol. They are pretty damn loud. I have a vid but it don't do them justice
0400x that was me at one point. I think there was some others as well. I have found I pretty much only have 1 option for mine and that's under the bed. Hope to install them soon. I was able to test them with a air compressor lol. They are pretty damn loud. I have a vid but it don't do them justice
Ya, i plan on getting a fly by vid of me blowin the horns, as well as my exhaust. Hopefully ill be able to get the second gen video done before june.
I also relocated my cb to my center console, pics will be up tommorow.
Called about the tranny flush and it's getting done Weds now. Ordered the relay/pressure switch and the Solenoid valve for my air horns. Got them both off ebay got the relay/pressure switch from Hornblasters and they shipped it a few hours later. Probably gonna order my compressor later tonight or tomorrow. Figure I need to get this stuff ordered so I can start saving for my other big project. Info on that can be found here https://dodgeforum.com/forum/off-top...ml#post2079420
Picked up my truck from the Dealership. Got a brand new transfer case. Mine cracked....at 48K miles!!!!
Not that bad. Warranty covered it (less $100 deductible).
The new ones are nice and shiny!!
Not that bad. Warranty covered it (less $100 deductible).
The new ones are nice and shiny!!
Checked all my fluids. Alls good except my front diff. i put axle seals in 3 weeks ago, and i must have messed up because my pass. axle seal is leaking again....pretty bad too....
found a nail in one of my new F'N tires. my treads are deep, and they are 10 ply...im not loosing any air but damn, they are a month and a half old...
This goes over the last week actually but I installed my new LED 3rd brake and tailights, gave the truck the biggest bath it's ever had, and gave the truck a full tune up...plugs, wires, cap, rotor, and all fluids. The truck has been sitting for the last two years with my dad driving it a bit every now and then to get the fluids moving while I've been in japan. The truck was extremely dirty cause they never washed it once and it was a tough job to get it clean. Only thing I didn't get to was the engine but it'll get done soon anyway since I put 1300 miles on it in two days and it's filthy again since I went through mountain passes with snow and all that fun salt/sand all over the roads. Oh and i fixed my turn signal issue...damn fuses.








