I estimate it to be about 30 x 50 with 5 bays....

I started and got workbenck set up and one pegboard. Can't find Igloo jug with clips for all my bakers rack shelving.... I hate it when everythingis in boxes - somewhere....

 

so jealous.

 

x2!!!

 

I'm gonna need to use that shop for my timing chain replacement! LOL!

 

Finally got er back together and fired it for the first time in weeks. Was nice to see the old girl running again! Now to get the timing set right , not looking forward to that.

 

Do not try to set the timing. The only timing adjustment is on the chain. It should still be set to spec unless you turned the timing sprockets durin installation. Turning the distributor on these engines does not work, it only changes fuel sync.

 

Haha gdstock I am jealous! My shop is three bays up top, 2 on bottom, but have car pit in one of the top bays. Here's the problem: When I want to put the truck over the car pit, I have about 1/2 inch clearance between the top of the door and the cab (yikes!). Wasn't designed to do mechanical work! Terribly full as well...

 

No lift for YOU! Unless you wanna air down your tires every time you want to pull it in the shop.....

 

haha I don't like lifts very much. It has a two inch lift on the rear right now AFAIK, but it is a very tight fit.. I told Dad I got the truck over the pit. He looks at me and says "You what?"... We tried a couple years ago but couldn't make it. Why? I don't know... Probably the shocks are sagging a little.

 

Seriously?