The Official 2nd Gen RAM Forum OT thread
06-06-2013, 06:42 PM
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,024
06-06-2013, 06:44 PM
Join Date: Jun 2010
Posts: 8,916
Likes: 0
Just a frame, and axles, and engine and transmission..
oh hell, everything!
06-06-2013, 08:46 PM
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
Discovered this during the whole 4 wheeler incident:
What's the best and/or easiest way to get that back in place?
06-06-2013, 08:48 PM
Join Date: Jun 2010
Posts: 8,916
Likes: 0
Looks like it was held on with silicone...
06-06-2013, 09:13 PM
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
I dunno. It was fine that day, and that night I noticed it was loose. I don't like the debadged look, so I wanna get it secure again, with minimal hassle
06-06-2013, 09:17 PM
Join Date: Oct 2009
Location: N/A
Posts: 4,712
3m two sided trim tape, pita to cut around it though.
06-06-2013, 09:20 PM
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
Quote:
Originally Posted by
merc225hp
3m two sided trim tape, pita to cut around it though.
Think I'll just do that. A scalpel should make the tape trimming a little easier.
06-06-2013, 09:43 PM
Join Date: Jun 2012
Location: Iowa
Posts: 3,096
Likes: 0
Or 3M trim adhesive will do the job just as well...
06-06-2013, 10:18 PM
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,024
06-06-2013, 10:55 PM
Join Date: Jun 2010
Posts: 8,916
Likes: 0
That guy has had way too much time on his hands...