The Official 2nd Gen RAM Forum OT thread
Jun 6, 2013 | 06:42 PM
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Jun 6, 2013 | 06:44 PM
Joined: Jun 2010
Posts: 8,916
Likes: 1
Just a frame, and axles, and engine and transmission..
oh hell, everything!
Jun 6, 2013 | 08:46 PM
Joined: Mar 2011
Posts: 8,914
Likes: 4
From: Fredericksburg, Virginia
Discovered this during the whole 4 wheeler incident:
What's the best and/or easiest way to get that back in place?
Jun 6, 2013 | 08:48 PM
Joined: Jun 2010
Posts: 8,916
Likes: 1
Looks like it was held on with silicone...
Jun 6, 2013 | 09:13 PM
Joined: Mar 2011
Posts: 8,914
Likes: 4
From: Fredericksburg, Virginia
I dunno. It was fine that day, and that night I noticed it was loose. I don't like the debadged look, so I wanna get it secure again, with minimal hassle
Jun 6, 2013 | 09:17 PM
Joined: Oct 2009
Posts: 4,717
Likes: 10
From: N/A
3m two sided trim tape, pita to cut around it though.
Jun 6, 2013 | 09:20 PM
Joined: Mar 2011
Posts: 8,914
Likes: 4
From: Fredericksburg, Virginia
Quote:
Originally Posted by
merc225hp
3m two sided trim tape, pita to cut around it though.
Think I'll just do that. A scalpel should make the tape trimming a little easier.
Jun 6, 2013 | 09:43 PM
Joined: Jun 2012
Posts: 3,096
Likes: 2
From: Iowa
Or 3M trim adhesive will do the job just as well...
Jun 6, 2013 | 10:18 PM
Joined: Jun 2009
Posts: 8,025
Likes: 72
From: orangeville ontario
Jun 6, 2013 | 10:55 PM
Joined: Jun 2010
Posts: 8,916
Likes: 1
That guy has had way too much time on his hands...
