Just installed efan and love it!
jhvbhjn_zps715bcb1b.jpg?t=1364181456
wiring out of whole in the shroud. came this way from the factory
jkbjnb_zpse6729999.jpg?t=1364181458
fan switch wire from ac compressor. turns fan on when compressor runs
jglhgl_zpsf3575fd2.jpg?t=1364181454
temp probe in rad.
hghj_zpse7c526b7.jpg?t=1364181342
Fan in the shroud all mounted up
wiring out of whole in the shroud. came this way from the factory
jkbjnb_zpse6729999.jpg?t=1364181458
fan switch wire from ac compressor. turns fan on when compressor runs
jglhgl_zpsf3575fd2.jpg?t=1364181454
temp probe in rad.
hghj_zpse7c526b7.jpg?t=1364181342
Fan in the shroud all mounted up
hvjhvb_zps44dc9309.jpg?t=1364182423
the wiring..i would relocate the relay to the same side of the controller because of grille clearing issue.
then you got all this snow in spring
kjhgvb_zpsb020facc.jpg?t=1364182424
the wiring..i would relocate the relay to the same side of the controller because of grille clearing issue.
then you got all this snow in spring

kjhgvb_zpsb020facc.jpg?t=1364182424
that is expensive. for that price i would have used the jeep recall fan. then you would not have had to buy a special 70 amp relay.
I will find all my receipts and add it up to give you am exact price. Plus I should have looked in a junkyard before I got one offline because it would have been about 20-30 dollars cheaper
Question?
All the previous posts I have seen of the E-Fan conversions have had two efans side by side.
Is this one fan enough ?
If the one fan setup is GTG, this is definatly on my short list of mods do.
All the previous posts I have seen of the E-Fan conversions have had two efans side by side.
Is this one fan enough ?
If the one fan setup is GTG, this is definatly on my short list of mods do.




