Hello out there !

My name is Peter and I´m writing from Austria. I´ve a 2001 Ram V10 and it looks like my tranny has gone (slipping). My ride has 190.000 on it and so it´s time to rebuild my tranny.
For that reason I´m looking for special tools to do the job. Especially I´m looking for the OD spring compressor and alignment tool and the tools for measuring the endplay.
Perhaps somebody would sell these tools and could send them to Austria.

In advance thanks for your feedback,
Peter

 

One member just made up a spring compressor tool...... and could you use the shaft that goes in there for an alignment tool?

 

This special tool s "only" a shortened intermediate shaft.
I think I can use the shaft from this member as alignment tool.
Here are the original Chrysler numbers for the special tools I´m looking for:

Compressor tool: 6227-1
Alignment tool: C-6227-2
Measuring tool: 6312
Gauging bar: 6311